Rodeo
A stand for a Sybian, which gives some padding for the knees, different heights, better angle for the ankles and some sound damping.
It's also possible to secure a person on it. This is done by two chains or belts with a ring in the end, and you pull each chain through the other chain's ring, and tighten to the rings on the box, with the loop that's created in the middle around the waist. This is not modeled here, as it's more work to model it than it's worth.
Through the use of a stacked board, the height can be adjusted.
The empty spaces under the leg rests are meant to be half filled with sand, to absorb sound.
Not modeled her, due to absent-mindedness, are rubber feet to minimize sound propagation through the floor.
Files
OpenSCAD file: rodeo.scad
Photos
|
|
|
|
|
|
|
|
|
Animations
360 degree view animation.
|
Images
Front view, with riser installed. This means about normal height.
|
Front view, without riser installed. This means about 57.5 mm below normal height.
|
Front view, with riser, but without Sybian.
|
Front view, without riser, but without Sybian.Observe the rubber gaskets for sound damping.
|
Front view, with riser, but without Sybian.The top of the riser is removed to show the construction.
|
Front view, but with pads removed to show the construction.The empty spaces should be half filled with sand.
|
Inspiration
Revision history
2021-12-06 First version.
2023-02-28 Built it and added photos.
2023-07-25 Added photos.